Resin builds up over time in a bong, a glass water pipe commonly used to consume cannabis. As a result, the glass surfaces are left with a sticky film. The bong will no longer be usable if the stickiness increases to an unacceptable level. Both the water’s color and the cannabis’ flavor are affected. Improve your cannabis smoking experience by following the steps outlined in this article to maintain your smoking equipment clean, functional, and smelling and tasting great.
Remove the bowl and stem.
Your cannabis from places like Canna Craft Collective should go in the bowl, and the stem should go in your mouth. This piece is detachable, which simplifies the process of cleaning the bong. When using a bong, it’s important to avoid getting the bowl wet.
Empty the old water.
Sticky and resinous, bong water shouldn’t be flushed down the toilet. If you don’t have a sealed trash bag, pour it into a sealed container before throwing it away. Bongwater can be dumped outside, but it shouldn’t be used to water plants. Plants are susceptible to the same bacteria and mold that could harm them.
Place the bong in a zip-top bag.
The mess might be contained in a giant gallon-size bag. It is possible to carry out the following procedures in a garbage bag or even over a sink if you do not have a bag with a zip-top closure. Be careful, though; bong resin has a nasty habit of sticking to sinks.
Fill the bong with isopropyl alcohol.
Pour some liquor into the bong. Fill the bong with 16 ounces of liquid, or approximately one-third full. To clean the bong, use isopropyl alcohol. Substituting vinegar and baking soda for isopropyl alcohol is possible.
Fill the bong halfway with salt.
You can clean the bong’s resin interior using this salt as a mild scrub. Although the alcohol does a decent job of removing debris, the salt is necessary to get the buildup off the bong’s inside walls. Make sure the salt can scour the resin by using a suitable amount.
Shake the bag.
Avoid a mess by sealing the bag and shaking the alcohol and salt mixture inside the bong. Make sure the mixture enters all the chambers of the percolator bong. You may infuse every nook and cranny by inverting the bong several times.
Allow 30 minutes for it to soak.
Take around 30 minutes to let the bong’s alcohol mixture settle. Depending on how grimy your bong gets, soaking it in alcohol may be unnecessary, but doing so will make the alcohol work better.
Take the bong out of the bag and throw it away. The bag serves a useful purpose: used bong water may be easily contained, sealed, and discarded. As a result, there will be no more resin sludge in the drain.
Rinse the bong with warm water and soap.
Since alcohol can catch fire, it’s best to empty the bong of booze and salt before lighting up. You can clean the glass with dish soap and hot water to eliminate residual grease.
Soak the bowl and stem in alcohol to clean them.
Use a pipe cleaner to remove any accumulated resin in the stem. Before loading it with cannabis, wash it well in hot water and let it dry inside and out. For you to enjoy fast and reliable weed delivery, there are multiple shops that offer this service so you better take advantage of them.
Conclusion
Unlike dusting or washing the dishes, routinely cleaning your glass pipe or bong is mandatory. It’s nasty to inhale leftover tar or have your smoke lose flavor if you use an unclean pipe. If you’re tired of getting a mouthful of stale bong water every time you light up instead of the delicious tastes of your cannabis, it’s time to learn how to properly clean your bong.
